Turn Signal Lights Dynamic Sequential LED for Seat Ateca Cupra 5D 2016-2021
Raise your road presence with these dynamic sequential LED turn signal lights designed exclusively for the Seat Ateca, Cupra Ateca, and Seat Tarraco models produced between 2016 and 2021. Unlike standard blinking bulbs, these indicators project a smooth horizontal sweep animation that clearly communicates your turning intention to nearby drivers, drastically cutting blind-spot confusion during lane changes or highway merges. Each unit channels 2400 lumens through modern LED arrays, delivering sharp illumination in both daylight and low-light conditions while drawing minimal power from your 12 V vehicle network.
The thick, smoke-tinted matte lenses sit behind glossy black outer casings that resist everyday scratches and match the sporty aesthetic of factory-side mirrors. An IP67 waterproof seal protects the internal circuitry from rain and road spray, eliminating the flickering or premature failure common with cheaper aftermarket replacements. Because the harness aligns perfectly with your original mirror connectors, swapping out old units takes minutes and requires zero electrical guessing.
Practical Benefits & Setup Tips
- Direct Drop-In Fit: Connect straight into the existing mirror plug—no resistor modules, coding, or custom wiring looms needed.
- Early Activation Advantage: Engage the signal slightly before completing your turn so the sequential wipe fully reaches the lens edge, maximizing driver awareness.
- Preserve the anti-reflective matte coating by wiping the lens with a dry microfiber cloth; avoid abrasive pads or ammonia-based cleaners that could dull the surface.
Technical Specifications
Voltage: 12 V System
Luminous Flux: 2400 LM per lamp
Housing Finish: Glossy black exterior, semi-smoked matte interior lens
Vehicle Compatibility: Seat Ateca (2016–2021), Cupra Ateca (2018–2021), Seat Tarraco (2018–2019)
Safety & Compliance Certifications: IP67 sealed, E-Mark, CE, DOT, SAE approved
Weight: 0.2 kg (complete pair)
Package Includes
- 1 × Left-Side Dynamic Sequential LED Turn Signal
- 1 × Right-Side Dynamic Sequential LED Turn Signal
Installation & Usage Reminders
A printed installation manual is not included, and connecting the plug-and-play harness through an experienced motor technician is highly recommended. Please cross-reference your side-mirror housing shape and connector pin count before ordering, as certain trim packages differ across model years. Expect normal manufacturing tolerances of 1 to 2 mm from manual measurements, and note that monitor calibrations may render the smoked tint slightly different than shown in reference photography.
All electronic and mechanical equipment, devices and machines sold by InterCyprus to EU countries are CE certified and carry a two year warranty.
Consistent spare part sourcing since 2002 at intercyprus.com — dependable solutions kept off the bargain-bin shelf.