90 Degree PTFE Swivel Fitting Kit For Fuel And Oil Lines AN4 6 8 10
This 90 degree swivel fitting closes off fuel leaks so your ethanol and high-performance engine runs reliably.
The one-piece aluminum body attaches directly to your line without extra brazed joints.
That single design cuts down potential leak points and improves fluid flow.
A mechanical clamp grips the PTFE hose core tightly.
Another clamp locks the stainless steel outer braid firmly in place.
You can easily route the angled connector around tight components in any engine bay.
Benefits & Tips
Install these connectors across fuel injector rails, nitrous kits, or coolant crossover pipes.
AN numbers show tubing inner diameter, not millimeter width.
Always measure your hose wall carefully before ordering.
Keep this hardware strictly paired with PTFE braided hoses.
Standard rubber or CPE lines will not accept the clamping mechanism.
Product Specifications
- Material: Black anodized aluminum.
- Design: 90 degree swivel hose end adaptor.
- Sizes: AN4, AN6, AN8, and AN10.
- Fitment: Matches tubing inner diameters of 1/4, 3/8, 1/2, and 5/8 inches.
- Application: E85 ethanol, fuel, oil, air, gas, and water lines.
Package includes: One swivel fitting per purchase.
Warnings & Reminders
Verify your hose inner diameter carefully before ordering.
This assembly only works with genuine PTFE construction.
It is incompatible with CPE tubes or standard rubber hoses.
Manual measuring may cause minor size differences.
Screen settings might make the black finish appear slightly lighter than expected.
All electronic and mechanical equipment, devices and machines sold by InterCyprus to EU countries are CE certified and carry a two year warranty.
Serving car enthusiasts at intercyprus.com since 2002 means we stand behind every mechanical upgrade with trusted service and steady reliability.
Supported language: English.