4X4 LED Strobe Warning Light With Wireless Remote Control For Emergency Vehicles
Get noticed on the road instantly with this 4X4 LED strobe warning light designed for tough daily routes and professional duty cycles. The sixteen high-power LEDs cast a visible strong light column that significantly raises your presence among other drivers. You control three distinct strobe patterns plus a steady warning mode through a dedicated wireless remote. Built-in memory retains your final selection, saving you daily reprogramming steps behind the wheel. Rapid heat dissipation protects the internal circuitry from overheating during extended runs. That thermal management helps push usable service life past thirty thousand hours. The compact frame weighs only 270 grams for stress-free mounting on dashboards or grilles.
Benefits & Tips:
Position the assembly near your windshield or roof rack to clearly mark slow-moving utility transport or roadside repairs. Coordinate the flashing sequence with reflective vest markings to establish a rapid safety perimeter around your workspace. Always run a quick bench test with clamped power leads before drilling permanent holes or applying adhesive mounts. Store the transmitter in a zippered pocket to prevent accidental mode switches while parked overnight.
Product Specifications:
- System Voltage: Operates safely on standard 12V circuits found across cars, trucks, vans, and motorcycles.
- LED Array: Four external brackets house four diodes each for broad directional visibility.
- Energy Draw: Pulls between 12W and 18W when cycling through active flash patterns.
- Control Box: Internal module measures a precise 6.6 by 4.6 by 1.8 centimeters.
- Lead Length: Factory fittings provide 140cm and 100cm routing options for complex dash installations.
Package includes:
- Four-panel LED strobe warning light bar
- Main control unit with pre-attached wiring harness
- Wireless operating remote (battery sold separately)
Warnings & Reminders:
The black connector requires proper negative grounding while the red lead attaches directly to positive power sources. Connect the yellow wire directly to activate constant high-output illumination whenever immediate sightlines matter. You must load a fresh 12V 23A coin cell inside the remote before attempting initial signal pairing. Run a brief power test to lock your preferred flash pattern, then secure the bracket bolts firmly. Review local traffic regulations regarding emergency signaling colors on private property before deployment.
All electronic and mechanical equipment, devices and machines sold by InterCyprus to EU countries are CE certified and carry a two year warranty.
Proudly delivering dependable automotive accessories since 2002 through intercyprus.com — your trusted partner for safer driving gear.
This interface and instruction set are fully prepared for English navigating operators during initial setup.
Mount an extra unit on your trailer hitch to broadcast clear hazard signals to drivers approaching from tight blind corners.