Automatic Start Stop Off Switch for Audi A4 S4 RS4 B9 2016-2024
Keep your Audi’s automatic start-stop system permanently disabled with this plug-and-play control module engineered specifically for the B9 platform. Most drivers find factory idle start-stop systems irritating during heavy city traffic, winter warmups, or extended idling, as forced re-engagement causes premature starter wear, increased fuel consumption, and accelerated 12-Volt battery drainage. This adaptation kit intercepts the original wiring harness, overriding the default behavior so the engine starts quietly without cranking the combustion chamber again. Designed for straightforward integration, the unit slots between your dashboard’s factory socket and the existing button backplate, requiring zero diagnostic software or ECU flashing.
Once connected and calibrated, the activation indicator shifts to red automatically, locking out the idle restart function across every ignition cycle. You retain full manual control by simply tapping the control to temporarily allow start-stop engagement when needed.
Benefits & Tips
- Protect Critical Components: Eliminating repetitive micro-starts drastically reduces thermal stress on the starter motor, flywheel teeth, and alternator bearings.
- Prolong Battery Health: Prevents deep discharge cycles caused by frequent ignition kicks, keeping your AGM or conventional lead-acid battery within optimal voltage ranges.
- Calibration Routine: After wiring, press the brake pedal and crank the engine while leaving the new switch untouched for approximately three to six seconds. The internal LED will turn red once, confirming the permanent offline mode is successfully saved to your vehicle’s module memory.
Product Specifications
- Vehicle Fitment: Audi A4, S4, RS4 (B9 chassis)
- Fabrication Years: 2016–2024
- Type: Automatic Start/Stop Override Switch & Harness
- OEM Cross-Reference: For Audi A4 S4 RS4 B9
- Item Weight: Approximately 80 g
- Manufacturing Origin: Mainland China
Package Includes
- 1 × Automatic Start/Stop Off Control Cable Assembly
- 1 × Trim Panel Removal & Fitting Tool
Warnings/Reminders
This aftermarket controller is strictly compatible with vehicles that already feature a factory-installed 'A OFF' dashboard button for start-stop management. If your original interior lacks this specific switch, the adapter harness cannot terminate correctly and will not function. Installation requires gentle removal of the relevant trim piece and routing the cable between the manufacturer connector and the button rear socket. Wire paths and panel clips may differ slightly based on your exact manufacturing month; always clear obstructions before applying pressure to the dashboard assembly.
All electronic and mechanical equipment, devices and machines sold by InterCyprus to EU countries are CE certified and carry a two year warranty.
Relying on precision-engineered automotive accessories and dependable service since 2002 at intercyprus.com — your safe choice for trusted parts online.