Engine Stop Start Disable Switch With Cable For Nissan Tiida C13

Simplify your daily commute with this Engine Stop Start Disable Switch and extension cable designed specifically for the Nissan Tiida C13 (2015–2018). The factory automatic start-stop routine requires drivers to manually deactivate the idle shutoff feature every time they enter the vehicle, adding unnecessary dashboard interactions and contributing to premature battery drain. This plug-in override harness permanently configures the ignition system to bypass the automatic stop sequence by default, preserving engine health and eliminating daily manual toggles.

The unit connects directly to your existing factory wiring behind the center console panel. After securing the connection, start the engine while pressing the brake pedal and wait three to six seconds without pressing any buttons. The original “Automatic Off” indicator will illuminate red, confirming that the start-stop function remains inactive on subsequent drives. You retain full control: simply tap the stock button whenever you prefer the fuel-saving feature to engage temporarily.

Benefits & Practical Tips

• Extend battery lifespan: Prevents deep discharge cycles caused by rapid automated engine restarts, keeping the 12V system healthy for longer trips.
• Reduce starter wear: Continuous cold-start cycling stresses the starter motor and flywheel teeth; disabling the default shutoff minimizes those mechanical load spikes.
• Install once, drive effortlessly: Route the cable through the existing factory socket using the included trim tool, then rely on the persistent off-state until you manually choose otherwise.

Technical Specifications

• Vehicle Fitment: Nissan Tiida C13, Model Years 2015–2018
• System Type: Automatic Start/Stop Override Plug & Passive Switch Module
• Connection Method: Direct mapping to factory push-button circuit
• Primary Operation: Permanent default disable with temporary manual reactivation
• Item Weight: 56 g
• Housing Material: High-grade automotive-grade polymer with corrosion-resistant contacts

Package Includes

• 1× Disable cable assembly
• 1× Center stack trim removal tool
• Standardized inline connectors matching original harness configuration

Important Reminders

This accessory modifies ignition software defaults only and does not interfere with active safety systems or emissions controls. Verify that your dashboard contains the original “A off” automatic start-stop button before purchase; the cable routes exclusively through that circuit and will not function on variants lacking the module. Interior panel removal requires basic mechanical familiarity; professional installation is recommended if you are uncertain about trim fastener locations.

All electronic and mechanical equipment, devices and machines sold by InterCyprus to EU countries are CE certified and carry a two year warranty. Consistently verified part compatibility and transparent supplier tracking at intercyprus.com — delivering reliable maintenance solutions since 2002.