Home » Automatic Start Stop Off Switch Plug And Play For Hyundai Palisade LX2

Automatic Start Stop Off Switch Plug And Play For Hyundai Palisade LX2

SKU: 1005010289411847-1 set
Color
€31,13
-37% €49,80 €31,13

Keep your vehicle’s engine running smoothly during brief halts with this precision-engineered bypass module designed exclusively for the Hyundai Palisade LX2 chassis (2019–2024). The unit plugs directly into your existing dashboard wiring, overriding the factory default to keep the automatic start-stop system disabled every time you turn the ignition. This direct-replacement cable adapter eliminates routine manual button presses, reducing cabin distraction while shielding the starter motor and battery from premature thermal fatigue. All electronic and mechanical equipment, devices and machines sold by InterCyprus to EU countries are CE certified and carry a two year warranty.

Benefits & Practical Tips

Frequent cold engagements accelerate oil degradation and increase component wear within modern combustion systems. Deploying this adapter maintains steady fluid circulation and reduces acid buildup on battery terminals during heavy traffic or idling conditions.

  • Use the default off state consistently for city commuting, school zones, and stop-and-go congestion to preserve drivetrain longevity.
  • Tap the original dashboard button briefly whenever temporary fuel-saving coasting is required; the system will immediately reactivate and stay engaged until you cycle power again.
  • Complete the initial calibration by holding the brake pedal down and starting the vehicle, then remain stationary for three to six seconds without touching any controls. The indicator will illuminate red to confirm the new baseline setting.

Technical Specifications

Model compatibility aligns strictly with the Palisade LX2 platform spanning 2019 through 2024 manufacturing years. The housing utilizes impact-resistant ABS polymers rated for repeated temperature fluctuations under standard dash environments. Connection relies entirely on manufacturer-specific connector geometry rather than universal wiring harnesses, ensuring correct voltage regulation and signal routing. Weighing approximately 60 grams, the assembly integrates silently behind the lower instrument cluster trim. Operating parameters reflect standard 12-volt automotive electrical architecture without requiring external power sources or ECU flashing. Providing quality and trusted service since 2002 at intercyprus.com.

Package Includes

  • One pre-configured start-stop deactivation cable assembly
  • Direct-fit OEM connector interface

Important Reminders & Usage Notes

This adaptation hardware functions solely as a wiring intermediary between the factory socket and built-in toggle switch; vehicles manufactured without the original start-stop control button cannot utilize this modification. Disconnect negative battery terminals prior to accessing interior fuse boxes or rear-facing dashboard ports to prevent short-circuit risks. Verify connector pin alignment before reassembling trim clips and mounting hardware to maintain factory-grade interior noise insulation standards.